Revision History of FMC10

ULM

Version （Revision) No.	Date	Contents
		Common to ULM for FMC40. Click here.

FMC

Version （Revision) No.	Date	Contents
3.00 050305	2005/03/08	Fixed: “FAN ERROR” of the option unit is not shown on the operation panel and all the errors of the option unit are shown as “STITCH ERROR” instead. In this new version, if any fault occurs on the fan of the option unit, the operation panel first shows “OPTION UNIT ERROR” and by pressing the “STOP FACT” key, the panel shows “STC. UNIT FAN ERROR”. This is true with other errors of the option unit.
3.00 030325	2003/03/26	Fixed: There are cases where machine data cannot be loaded. The machine data routine has been modified accordingly.
3.00 020820	2002/08/20	Fixed: 1. When operating V-LEC4DGTY, Approx. 20 needles to the right of the start needle knit “Tuck-Welt” instead of “Knit-Welt” in the first revolution after executing “RESET PARAMETER”. 2. “ACTUATOR ERROR” is sometimes erroneously displayed.
3.00 020320	2002/03/20	Fixed: In the case of a very-large-sized striper pattern, the striper data cannot be transferred to the controller.
3.00 020206	2002/02/06	Fixed: Finger information cannot be loaded after installing V.3.00 020116 on a transfer machine. (In this case, it was made possible by resetting the1 transfer feeder.) It is now possible to load finger information without resetting the transfer feeder.
3.00 010928	2001/10/26	Fixed: 1. Machine data can not be entered on machines with catch & release type stripers after clearing the memory of DSP1 board. 2. When auto-stitch is set to test mode on V-LEC4DGTY, the stitch amounts of the No-finger feeders are set to 1. 3. On striper machines, when changing a pattern using take-off feeders to a pattern using all feeders, needles come up before the striper finger is set to the position, this resulting in fabric fall-off, or needles do not come up even if the striper finger has already been set to the position, this resulting in entwined yarns around the knitting elements.
3.00 010424	2001/05/07	Fixed: (For SEC4BCY) 1. No warming-up operation is performed at gate. 2. Unnecessary finger movement found at a certain feed if the striping data is the same as one revolution before.